Checking Configurations; Example For Applying Igmp Filtering On Interface - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Step
4

8.6.7 Checking configurations

Use the following commands to check configuration results.
No.
1
2

8.6.8 Example for applying IGMP filtering on interface

Networking requirements
Enable IGMP filtering on the switch. Add filtering rules on the interface to filter multicast
users.
As shown in Figure 8-10,



Configure the maximum number of multicast groups on GE 1/1/1. After the STB is added to
the 234.5.6.7 multicast group, add it to the 234.5.6.8 multicast group while it quits the
234.5.6.7 multicast group.
Command
Raisecom(config-
gigaethernet1/1/port)#igmp
filter max-groups action
{ drop | replace } [ vlan
vlan-list
]
Raisecom(config-port-
channel1)#igmp filter max-
groups action { drop |
replace } [ vlan
Raisecom#show igmp filter [ interface |
interface-type interface-number
vlan id
- ] ]
Raisecom#show igmp filter profile
[ profile-number
Create an IGMP filtering rule Profile 1, and configure the action to pass for the multicast
group ranging from 234.5.6.7 to 234.5.6.10.
Apply filtering rule on GE 1/1/1, allow the STB to join the 234.5.6.7 multicast group,
forbid it to join the 234.5.6.11 multicast group.
Apply no filtering rule on Port 3, and allow PCs to join the 234.5.6.11 multicast group.
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
(Optional) configure the action over
maximum number of multicast groups in
physical interface or interface+VLAN.
(Optional) configure the action over
maximum number of multicast groups in
LAG interface or interface+VLAN.
vlan-list
]
Command
[ vlan
]
8 Multicast
Description
Description
Show configurations of
IGMP filtering.
Show information about
the IGMP profile.
348