Table of Contents
Advertisement
Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Step
2
3
2.4.8 Checking configurations
Use the following commands to check configuration results.
No.
1
2
3
2.4.9 Example for configuring basic QinQ
Networking requirements
As shown in Figure 2-7, Switch A and Switch B are connected to two branches of Department
C, which are in different locations. Department C uses VLAN 100, and needs to communicate
through VLAN 1000 of the carrier network. The carrier TPID is 9100.
Configure basic QinQ on Switch A and Switch B to enable normal communication inside a
department through the carrier's network.
Command
Raisecom(config)#interface
interface-type interface-number
Raisecom(config-
gigaethernet1/1/port)#tpid
Command
Raisecom#show dot1q-tunnel
Raisecom#show vlan-mapping both
interface interface-type
interface-number
Raisecom#show vlan-mapping
interface interface-type
interface-number
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Description
Enter physical layer interface
configuration mode.
Configure the TPID of the outer
tpid
VLAN Tag on the interface.
Description
Show configurations of basic QinQ.
Show configurations of selective
QinQ.
Show configurations of selective QinQ
of EtherType on the interface.
2 Ethernet
79
Advertisement
Table of Contents
