Checking Configurations - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
1
2
3
4
5
6




11.3.5 Checking configurations

Use the following commands to check configuration results.
1
Step
Raisecom#config
Raisecom(config)#link-state-
tracking group
Raisecom(config)#link-state-
tracking group
action { block-vlan
interface-type interface-number
delete-vlan
rind-id |
suspend-vlan
Raisecom(config)#link-state-
tracking group
{ enable | disable }
Raisecom(config)#interface
interface-type interface-number
Raisecom(config-
gigaethernet1/1/port)#link-state-
tracking group
{ downstream | upstream } ma-name
ma-name
cfm
One link-state group can contain several uplink interfaces. Link-state tracking will
not be performed when at least one uplink interface is Up. Only when all uplink
interfaces are Down will link-state tracking occur.
In global configuration mode, when you use the no link-state-tracking group
group-number command to disable link-state tracking, the link-state group without
interfaces will be deleted.
In physical layer interface configuration mode, use the no link-state-tracking
group group-number command to delete an interface. During the execution of this
command, if the link-state group contains no other interfaces and is disabled, it
will also be deleted.
Step
Raisecom#show link-state-tracking
group group-number
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Command
group-number
group-number
vlan-id
vlan-id
| flush-erps
vlan-id
group-number
trap
group-number
mepid level
level
Command
Description
Enter global configuration mode.
Create the link-state group and
enable link-state tracking.
Configure the mode for processing
fault on the link-state interface.
|
}
Configure Trap sending on link-
state tracking.
Enter physical layer interface
configuration mode.
Configure the link-state group of
the interface and interface type.
One interface can belong to only
one link-state group and be
configured as an either uplink or
downlink interface. The interface
can be bound with CC.
Description
Show configurations and
status of the link-state group.
11 Reliability
471