Table of Contents
Advertisement
Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Step
1
2
3
4
5
6
By default, traffic is automatically switched to the protection line when the working
line fails. Therefore, you need to configure ELPS switching control in some special
cases.
4.2.7 Checking configurations
Use the following commands to check configuration results.
No.
1
2
3
4.2.8 Maintenance
Maintain the ISCOM2600G-HI series switch as below.
Raisecom(config)#clear
ethernet line-protection
[
Command
Raisecom#config
Raisecom(config)#ethernet
line-protection
lockout
Raisecom(config)#ethernet
line-protection
force-switch
Raisecom(config)#ethernet
line-protection
manual-switch
Raisecom(config)#ethernet
line-protection
manual-switch-to-work
Raisecom(config)#clear
ethernet line-protection
line-id
end-to-end command
Command
Raisecom#show ethernet line-
protection [
line-id
Raisecom#show ethernet line-
protection [
line-id
Raisecom#show ethernet line-
line-id
protection [
Command
line-id
] statistics
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Enter global configuration mode.
Lock protection switching. After this
line-id
configuration, the traffic is not switched to the
protection line even the working line fails.
Switch the traffic from the working line to the
line-id
protection line forcedly.
Switch the traffic from the working line to the
line-id
protection line manually. Its priority is lower
than the one of FS and APS.
In non-revertive mode, switch the traffic from
line-id
the protection line to the working line.
Clear end-to-end switching control
commands, including lockout, force-switch,
manual-switch, and manual-switch-to-
work.
]
] statistics
] aps
Clear protection line statistic, including Tx APS
packets, Rx APS packets, latest switching time,
latest status switching time.
4 Ring network protection
Description
Description
Show configurations of the
protection line.
Show protection line statistics.
Show APS information.
Description
203
Advertisement
Table of Contents
