Figure 1-3 Networking With Device As Telnet Server - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
ISCOM2600G-HI series switch on the network. You do not need to connect a PC to each
ISCOM2600G-HI series switch.
Telnet services provided by the ISCOM2600G-HI series switch are as below:


Figure 1-3 Networking with device as Telnet server

Before accessing the ISCOM2600G-HI series switch through Telnet, you need to log in to the
ISCOM2600G-HI series switch through the Console interface and start the Telnet service.
Take the following configurations on the ISCOM2600G-HI series switch that needs to start
Telnet service.
Step
1
2
3
4
5
6
7
8
Telnet Server: run the Telnet client program on a PC to log in to the ISCOM2600G-HI
series switch, and take configuration and management. As shown in Figure 1-3,
ISCOM2600G-HI series switch is providing Telnet Server service at this time.
Command
Raisecom#config
Raisecom(config)#interface
fastethernet 1/0/1
Raisecom(config-
fastethernet 1/0/1)#ip
ip-address
address
mask
]
Raisecom(config)#telnet-
server accept
interface-list
Raisecom(config)#telnet-
server close terminal-telnet
session-number
Raisecom(config)#telnet-
server max-session
number
Raisecom(config)# telnet-
server access-list {
access-list number
access-list number
Raisecom(config)#telnet-
server disable
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Enter global configuration mode.
Enter out-of-band network management
interface configuration mode
Configure the IP address of the out-of-
band network management interface.
ip-
[
By default, it is 192.168.0.1/24. Both the
default user name and password are
raisecom.
(Optional) configure the interface in
interface-type
support of Telnet function.
(Optional) release the specified Telnet
connection.
(Optional) configure the maximum
session-
number of Telnet sessions supported by
the ISCOM2600G-HI series switch.
By default, it is 10.
(Optional) configure the ACL number of
ip
the Telnet.
ipv6
|
}
(Optional) disable Telnet Server. At the
same time, the corresponding port
number will be disabled.
1 Basic configurations
Description
13