Table of Contents
Advertisement
Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
7.4.3 Configuring SRED
Configure SRED for the ISCOM2600G-HI series switch as below.
Step
1
2
3
4
5
7.4.4 Checking configurations
Use the following commands to check configuration results.
1
2
7.5 Configuring traffic classification and traffic policy
7.5.1 Preparing for configurations
Scenario
Traffic classification is the basis of QoS. You can classify packets from the upstream device
according to the priorities and ACL rules. After classification, the ISCOM2600G-HI series
switch can perform corresponding operations on packets in different categories and provide
corresponding services.
A traffic classification rule will not take effect until it is bound to a traffic policy. You should
apply traffic policy according to current network loading conditions and period. Usually, the
ISCOM2600G-HI series switch limits the rate for transmitting packets according to CIR when
packets enter the network, and remarks priority according to service feature of packets.
Raisecom#config
Raisecom(config)#mls qos sred
profile-id
profile
Raisecom(sred)#sred [ color { red
| yellow } ] start-drop-threshold
start-drop value
drop probability value
Raisecom(config)#interface
interface-type interface-number
Raisecom(config-
gigaethernet1/1/1)#mls qos queue
queue-id
sred
No.
Command
Raisecom#show mls qos sred
profile-list
profile [
Raisecom#show mls qos queue
sred interface
interface-number
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Command
drop-probability
profile-id
]
interface-type
Description
Enter global configuration mode.
Create a SRED profile, and enter
SRED configuration mode.
Modify the SRED profile.
Enter physical layer interface
configuration mode.
Apply the SRED profile to the
interface.
Description
Show information about the SRED
profile.
Show SRED information about the
interface.
7 QoS
302
Advertisement
Table of Contents
