Configuring Mac Address Synchronization; Enabling Automatic Device Restart Upon Isf Merge - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
1
2
3
4
The change of the bridge MAC address may interrupt services for a short time.
If bridge MAC addresses of two ISFs are the same, these two ISFs cannot be
merged into an ISF.
When VRRP load balancing is configured in ISF mode, you must configure the ISF
bridge MAC address to be permanently reserved (also permanently reserved by
default).

3.6.7 Configuring MAC address synchronization

In ISF mode, after a switch interface quits a VLAN, it will delete the MAC address
corresponding to the VLAN on the interface. During the deleting process, it does not process
the MAC address synchronization request from other ISF member switches until it deletes the
MAC address. After the period for synchronizing MAC addresses expires, the interface will
receive and process the MAC address synchronization request from other ISF member
switches and add the MAC address to its MAC address table.
Configure MAC address synchronization for the ISCOM2600G-HI series switch as below.
Step
1
2
3

3.6.8 Enabling automatic device restart upon ISF merge

When multiple ISFs merge, they will elect according to role election rules. All member
devices of the loser ISF have to be restarted before joining the winner ISF.

Step Command
Raisecom#config
Raisecom(config)#isf
mac-address
persistent always
Raisecom(config)#isf
mac-address
persistent timer
Raisecom(config)#no
isf mac-address
persistent
Command
Raisecom#1#config
Raisecom#1(config)#mac-address
synchronizing enable
Raisecom#1(config)#mac-address
synchronizing long-interval
If automatic device restart upon ISF merge is disabled, you have to restart devices as
prompted by the system during ISF merge.
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Description
Enter global configuration mode.
Configure the ISF bridge MAC address to be
permanent when the master device leaves the ISF.
Configure the reservation time for the ISF bridge
MAC address to 10min when the master device
leaves the ISF.
Configure the ISF bridge MAC address to be
updated immediately when the master device
leaves the ISF.
Enter global configuration mode.
Enable MAC address
synchronization.
Configure the period for
time
synchronizing MAC addresses.
3 ISF
Description
171