Example For Configuring Gvrp; Figure 2-31 Gvrp Networking - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide

2.14.7 Example for configuring GVRP

Networking requirements
As shown in Figure 2-31, to dynamically register, deregister, and update VLAN information
between switches, configure GVRP on these switches. Detailed requirements are as below:






Figure 2-31 GVRP networking

Configuration steps
Step 1 Create VLANs and enable global GVRP.
Configure Switch A.
Raisecom#hostname SwitchA
SwitchA#config
SwitchA(config)#create vlan 5-10 active
SwitchA(config)#gvrp enable
Configure Switch B.
Raisecom#hostname SwitchB
SwitchB#config
Configure static VLANs 5–10 on Switch A and Switch C.
Configure static VLANs 15–20 on Switch D.
Configure static VLANs 25–30 on Switch E.
Configure the interfaces that are connected to other switches to Trunk mode, and enable
GVRP on these interfaces.
Configure the Join timer, Leave timer, and LeaveAll timer of GARP on each interface to
600, 3000, and 12000, in units of 10ms.
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
2 Ethernet
149