Configuring Interface Protection; Configuring Interface Isolation; Checking Configurations - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide

2.10.4 Configuring interface protection

Interface protection is unrelated with the VLAN to which the interface belongs.
Configure interface protection for the ISCOM2600G-HI series switch as below.
Step
1
2
3

2.10.5 Configuring interface isolation

Configure interface isolation for the ISCOM2600G-HI series switch as below.
Step
1
2

2.10.6 Checking configurations

Use the following commands to check configuration results.
1
2
Command
Raisecom#config
Raisecom(config)#inte
rface interface-type
interface-number
Raisecom(config-
gigaethernet1/1/port)
#switchport protect
Command
Raisecom#config
Raisecom(config)#protect-
group-id
group
interface-type interface-
number
No. Command
Raisecom#show switchport
protect
Raisecom#show protect-
group { all |
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Enter global configuration mode.
Enter physical layer interface configuration mode.
Enable interface protection. Interface isolation is
supported across devices in the ISF. Interface
isolation can be implemented based on LAG
interface, namely, between LAG interfaces, and
between a LAG interface and common interface.
Enter global configuration mode.
Create an interface isolation group. Configure
vlan-id
vlan
isolation VLANs associated with the group
and the list of isolated interfaces.
Show configurations of interface protection.
Show configurations of interface isolation.
group-id
}
Description
Description
Description
2 Ethernet
125