Raisecom
Gazelle S1020i-LI (A) User Manual
Supported network protocol
2.3.2 10/100/1000BASE-T electrical interface
Table 2-8 lists parameters of the 10/100/1000BASE-T electrical interface.
Table 2-8 Parameters of the 10/100/1000BASE-T electrical interface
Connector type
Transmission rate
Duplex mode
Specifications
2.3.3 Console interface
Table 2-9 lists parameters of the Console interface.
Table 2-9 Parameters of the Console interface
Connector type
Duplex mode
Electrical feature
Baud rate
2.3.4 Alarm output interfaces
The alarm output interface is embedded with an electromagnetic relay. When alarms are input
through the DI interface or overtemperature, abnormal interface status, or abnormal power
status occurs, the electromagnetic relay will output alarms based on the connection status of
the control terminal, notifying the on-site operation and maintenance personnel, and
meanwhile report the alarms to the Network Management System (NMS).
The alarm output interface is in form of 3-pin Phoenix connector with spaces of 5.08 mm, as
shown in Figure 2-7.
Parameter
Parameter
RJ45
10/100/1000 Mbit/s auto-negotiation
Full/Half duplex
When the transmission rate is 10/100 Mbit/s, we recommend
using Cat 5 or better STP cable.
When the transmission rate is 1000 Mbit/s, we recommend using
Cat 6 or better STP cable.
Parameter
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Description
IP
Description
Description
RJ45
Duplex UART
RS-232
9600 baud
2 Hardware structure
16