Example For Configuring Four Devices To Form Isf - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Step 3 Configure Switch A to standalone mode.
Configure Switch A as below:
Raisecom#1#config
Raisecom#1#(config)#isf-mode single
This config reboot go into effect, Please input 'yes' to reboot:yes
Will you change start-config ? please input 'yes' to change:yes
1970-01-01,08:36:35 System-4-SYSTEM_REBOOT:unit2: Change work Mode
reboot !
Operation successfully
BOOTROM starting ..
Step 4 Log in to Switch B. Configure it to standalone mode.
Raisecom#2#config
Raisecom#2(config)#isf-mode single
This config reboot go into effect, Please input 'yes' to reboot:yes
Will you change start-config ? please input 'yes' to change:yes
1970-01-01,08:36:35 System-4-SYSTEM_REBOOT:unit2: Change work Mode
reboot !
Operation successfully
BOOTROM starting ..

3.8.4 Example for configuring four devices to form ISF

Networking requirements
When the network grows rapidly, the central switch (Switch A) fails to meet forwarding
requirements. To implement easy management and maintenance, add three devices to form an
ISF with Switch A, as shown in Figure 3-17.
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
3 ISF
186