Automatically Updating Version And Configurations; Checking Configurations - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
these packets, the DHCP client resolves Option 150 for the IP address of the TFTP server and
resolves Option 67 for the name of the configuration file or system file according to naming
conversions, resolves Option 17 for the file path.
Prerequisite



1.5.3 Automatically updating version and configurations

Configure automatic update of version and configurations for the ISCOM2600G-HI series
switch as below.
Step
1
2
3
4
5
6



1.5.4 Checking configurations

Use the following commands to check configuration results.
No.
1
Configure the address pool on the DHCP server and configure Option 67 and Option 150
in the address pool.
Configure DHCP Client.
Command
Raisecom#config
Raisecom(config)#interface vlan
vlan-id
Raisecom(config-vlan1)#ip
address dhcp [ server-ip
address
]
Raisecom(config-vlan1)#auto-
config enable
Raisecom(config-vlan1)#exit
Raisecom(config)#auto-save
enable
Raisecom(config)#auto-load time
hour minute second
After configuring the ISCOM2600G-HI series switch, save configurations and
restart it. Then, it will automatically apply for the IP address and conduct update
operations.
Connect the DHCP client to the DHCP server properly. Connect the DHCP client
to the TFTP server properly.
Command
Raisecom#show auto-config
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Enter global configuration mode.
Enter Layer 3 interface configuration
mode.
Configure the DHCP client to apply
ip-
for the IP address through DHCP.
Enable automatic update of version
and configurations.
(Optional) enable automatic saving of
configurations.
(Optional) configure the time for
saving configuration after successfully
loading the configuration file.
Description
Show configurations of automatic update of
version and configurations.
1 Basic configurations
Description
28