Table of Contents
Advertisement
Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
When monitoring packets from the PC 1, you needs to assign GE 1/1/1 to connect to PC 1 as
the mirror source port, enable port mirroring on the ingress port and assign GE 1/2/1 as
monitor port to mirror packets to destination port.
When service packets from PC 1 enter the ISCOM2600G-HI series switch, the
ISCOM2600G-HI series switch will forward and copy them to monitor port (GE 1/2/1). The
monitor device connected to mirror the monitor port can receive and analyze these mirrored
packets.
The ISCOM2600G-HI series switch supports mirroring data stream on the ingress port and
egress port. The packets on the ingress/egress mirroring port will be copied to the monitor
port after the switch is enabled with port mirroring. The monitor port and mirroring port
cannot be the same one.
2.11.2 Preparing for configurations
Scenario
Port mirroring is used to monitor the type and flow of network data regularly for the network
administrator.
Port mirroring copies the port flow monitored to a monitor port or CPU to obtain the
ingress/egress port failure or abnormal flow of data for analysis, discovers the root cause, and
solves them timely.
Prerequisite
N/A
2.11.3 Default configurations of port mirroring
Default configurations of port mirroring are as below.
Port mirroring status
Mirroring the source port
2.11.4 Configuring port mirroring on local port
Configure local port mirroring for the ISCOM2600G-HI series switch as below.
Step
1
2
3
Function
Configure
Raisecom#config
Raisecom(config)#mirror-group
id
Raisecom(config)#mirror-group
id
vlan-id
remote-vlan
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Default value
Disable
N/A
Description
Enter global configuration mode.
group-
Create a port mirroring group.
group-
Configure the remote mirroring
VLAN for the mirroring group.
2 Ethernet
128
Advertisement
Table of Contents
