Configuring Selective Qinq - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Step
1
2
3
4
5




2.4.5 Configuring selective QinQ

Configure selective QinQ on the ingress interface for the ISCOM2600G-HI series switch as
below.
Step
1
2
3
4
Command
Raisecom#config
Raisecom(config)#interface
interface-type interface-number
Raisecom(config-
gigaethernet1/1/port)#dot1q-tunnel
Raisecom(config-
gigaethernet1/1/port)#switchport
qinq default-cvlan
Raisecom(config-
gigaethernet1/1/port)#switchport
reject-frame { tagged | untagged }
To use basic QinQ functions on an interface, configure its attributes first by
configuring it to the Access or Trunk interface and configuring the default VLAN.
When basic QinQ is enabled on the interface, all packets are processed as
untagged packets. If you configure the untagged packets to be discarded, tagged
packets are also discarded.
VLAN mapping based on VLAN+CoS and VLAN mapping based on VLAN cannot
be concurrently configured.
Raisecom#config
Raisecom(config)#interface
type interface-number
Raisecom(config-
gigaethernet1/1/port)#switchport vlan-
mapping-miss discard
Raisecom(config-
gigaethernet1/1/port)#switchport vlan-
mapping ethertype { arp | eapol |
flowcontrol l ip | ipv6
mpls | mpls-mcast | pppoe | pppoedisc |
protocol id
user-define
x75 }add-outer
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
vlan-id
Command
interface-
| loopback |
| x25 |
outer-vlan id
-
Description
Enter global configuration mode.
Enter physical layer interface
configuration mode.
Enable basic QinQ on the interface.
The device supports this
configuration on the LAG interface
or in ISF mode.
Configure basic QinQ, add double
Tags, and specify the PVID used by
the CVLAN and SVLAN.
Configure the types of packets
disallowed to be forwarded.
Description
Enter global configuration
mode.
Enter physical layer interface
configuration mode.
Configure the interface to
discard tagged packets that
fail to match selective QinQ
or VLAN mapping rules.
Configure EtherType
selective QinQ, and add
mapping rules for Tag
VLAN.
2 Ethernet
77