Checking Configurations; Example For Configuring Vlan Interface To Interconnect With Host; Figure 5-1 Vlan Interface Networking - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
3
4

5.1.7 Checking configurations

Use the following commands to check configuration results.
No.
1
2
3
5.1.8 Example for configuring VLAN interface to interconnect with
host
Networking requirements
As shown in Figure 5-1, configure the VLAN interface to the switch so that the host and the
ISCOM2600G-HI series switch can ping each other.

Figure 5-1 VLAN interface networking

Configuration steps
Step 1 Create a VLAN and add the interface to the VLAN.
Step
Raisecom(config-vlan1)#ip
management-traffic cos
Raisecom(config-vlan1)#ip
management-traffic mode double-
tagging [ inner-vlan
[ inner-cos
Command
Raisecom#show ip interface
brief
Raisecom#show ipv6 interface
brief
Raisecom#show ip management-
traffic
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Command
cos-value
vlan-id
]
cos-id
]
Description
Configure CoS of the
management VLAN.
By default, it is 6.
Configure the double-tagged
mode for management packets.
Description
Show configurations of the IP address of
the VLAN interface.
Show configurations of the IPv6 address
of the VLAN interface.
Show information about management
packets on the VLAN interface.
5 IP services
209