Table of Contents
Advertisement
Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Step
1
2
3
4
Configuring Tag overriding
Tags of some fields may be forged by the client because of some reasons. The client overrides
the original Tags. After Tag overriding is enabled, if PPPoE packets contain Tags, these Tags
are overridden. If not, add Tags to these PPPoE packets.
Configure Tag overriding for the ISCOM2600G-HI series switch as below.
Step
1
2
3
10.9.6 Checking configurations
Use the following commands to check configuration results.
No.
1
2
10.9.7 Maintenance
Maintain the ISCOM2600G-HI series switch as below.
Command
Raisecom#config
Raisecom(config)#interface
interface-type interface-number
Raisecom(config-
gigaethernet1/1/1)#pppoeagent
remote-id { client-mac | switch-
mac }
Raisecom(config-
gigaethernet1/1/1)#pppoeagent
remote-id format { ascii | binary }
Command
Raisecom#config
Raisecom(config)#interface
interface-type interface-number
Raisecom(config-
gigaethernet1/1/1)#pppoeagent
vendor-specific-tag overwrite enable
Command
Raisecom#show pppoeagent
Raisecom#show pppoeagent statistic
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Description
Enter global configuration mode.
Enter physical layer interface
configuration mode.
(Optional) configure PPPoE+
Remote ID to be padded with the
MAC address.
(Optional) configure the padding
modes of the PPPoE+ Remote
ID.
Description
Enter global configuration mode.
Enter physical layer interface
configuration mode.
Enable Tag overriding.
Description
Show PPPoE+ configurations.
Show PPPoE+ statistics.
10 Security
449
Advertisement
Table of Contents
