Table of Contents
Advertisement
Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Configuring Circuit ID
The Circuit ID has 2 padding modes: Switch mode and ONU mode. By default, Switch mode
is adopted. In ONU mode, the Circuit ID has a fixed format. The following commands are
used to configure the padding contents of the Circuit ID in Switch mode.
In switch mode, the Circuit ID supports 2 padding modes:
Configure Circuit ID for the ISCOM2600G-HI series switch as below.
Step
1
2
3
4
In default mode, the Circuit ID contains an attached string. By default, the attached string is
configured to the hostname of the switch. You can configure it to a customized string.
Configure the attached string of the Circuit ID for the ISCOM2600G-HI series switch as
below.
Step
1
2
Configuring Remote ID
The Remote ID is padded with a MAC address of the switch or a client. In addition, you can
specify the form (binary/ASCII) of the MAC address.
Configure the Remote ID for the ISCOM2600G-HI series switch as below.
Default mode: when customized Circuit ID is not configured, the padding content is the
VLAN ID, interface number, or the attached string. If the attached string is not defined, it
is configured to hostname by default.
Customized mode: when customized Circuit ID is configured, the padding content is the
Circuit ID string.
Command
Raisecom#config
Raisecom(config)#pppoeagent
circuit-id { attach-string |
format | hex }
Raisecom(config)#interface
interface-type interface-number
Raisecom(config-
gigaethernet1/1/1)#pppoeagent
string
circuit-id
Command
Raisecom#config
Raisecom(config
)#pppoeagent
circuit-id
attach-string
string
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
string
Enter global configuration mode.
(Optional) configure the attached string of the Circuit ID.
If the Circuit ID is in default mode, attached string
configured by this command will be added to the Circuit
ID.
Description
Enter global configuration mode.
Configure the attached string of
Circuit ID.
Enter physical layer interface
configuration mode.
(Optional) configure the Circuit ID
to the customized string.
Description
10 Security
448
Advertisement
Table of Contents
