Checking Configurations; Example For Configuring Port Mirroring - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Step
4
5
6
7
8

2.11.5 Checking configurations

Use the following commands to check configuration results.
No.
1

2.11.6 Example for configuring port mirroring

Networking requirements
As shown in Figure 2-24, the network administrator wants to monitor user network 1 through
the monitor device, then to catch the fault or abnormal data flow for analyzing and
discovering faults and then solve them in time.
The ISCOM2600G-HI series switch is disabled with storm control and automatic packets
sending. User network 1 accesses the ISCOM2600G-HI series switch through GE 1/1/1, user
network 2 accesses the ISCOM2600G-HI series switch through GE 1/1/2, and the data
monitor device is connected to GE 1/1/3.
Configure
Raisecom(config)#mirror-group
id
reflector-port
interface-number
Raisecom(config)#interface
interface-type interface-number
Raisecom(config-
gigaethernet1/1/port)#mirror-group
group-id
monitor-port
Raisecom(config-
gigaethernet1/1/port)#mirror-group
group-id source-port { ingress |
egress }
Raisecom(config-
gigaethernet1/1/port)#exit
Raisecom(config)#mirror-group
id
source-cpu [ ingress | egress ]
Command
Raisecom#show mirror-
group-id
group [ ]
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
group-
interface-type
group-
Show configurations of port mirroring.
Description
Configure the reflector interface
for the mirroring group.
Enter physical interface
configuration mode.
Configure the monitor port for
mirroring.
Configure the mirroring port of
port mirroring, and designate the
mirroring rule for port mirroring.
Port mirroring supports
mirroring packets in both the
ingress and egress directions of
the port.
Configure port mirroring to
mirror packets to or from the
CPU.
Description
2 Ethernet
129