Configuring Vlan Based On Ip Subnet; Checking Configurations - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Step
3
4
5



2.2.10 Configuring VLAN based on IP subnet

Configure the VLAN based on IP subnet for the ISCOM2600G-HI series switch as below.
Step
1
2
3
4

2.2.11 Checking configurations

Use the following commands to check configuration results.
No.
1
2
Raisecom(config)#interface
interface-type interface-number
Raisecom(config-
gigaethernet1/1/port)#ip-subnet-vlan
enable
Raisecom(config-
gigaethernet1/1/port)#vlan
precedence { mac-vlan | ip-subnet-
vlan }
If the IP address or subnet mask is invalid, the configuration will fail.
If you associate a created IP subnet to a VLAN but this association conflict with an
existing association (for example, the IP subnet is associated with different
VLANs), the association will fail.
Raisecom#config
Raisecom(config)#protocol-vlan
protocol-index
ethertype protocol-id
Raisecom(config)#interface
interface-type interface-number
Raisecom(config-
gigaethernet1/1/port)#switchport
protocol-vlan
vlan-id
Command
Raisecom#show vlan [
| static | dynamic ] [ detail ]
Raisecom#show mac-vlan [ mask |
efficient ]{ all | vlan
id }
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Command
Command
{ ipv4 | ipv6 |
}
protocol-index
vlan
vlan-list
vlan-
Description
Enter physical layer interface
configuration mode.
Enable VLAN partitions based
on IP subnet.
(Optional) configure priorities of
MAC-VLAN and IP subnet
VLAN.
Description
Enter global configuration mode.
Configure the rule for
associating the protocol VLAN
with Ethernet packets.
Enter physical layer interface
configuration mode.
Configure the rule for
associating the interface with the
protocol VLAN.
Description
Show VLAN configurations.
Show MAC VLAN configurations.
2 Ethernet
64