Table of Contents
Advertisement
Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
6.2.4 Configuring DHCP Client
Configure DHCP Client for the ISCOM2600G-HI series switch as below.
Step
1
2
3
6.2.5 (Optional) configuring zero-configuration polling
Configure zero-configuration polling for the ISCOM2600G-HI series switch as below.
Step
1
2
6.2.6 Checking configurations
Use the following commands to check configuration results.
No.
1
Configure the interface connected to the zero-configuration server to be Up.
Configure the upstream switch to allow packets of a VLAN of the remote device to pass.
Out-of-band interface FE 1/0/1 supports obtaining the IP address through DHCP or zero-
configuration.
Command
Raisecom#config
Raisecom(config)#ip
dhcp client mode
{
zeroconfig
|
normal
Raisecom(config)#ipv6
dhcp client mode
{
zeroconfig
|
normal
Raisecom(config)#ip
dhcp client
{
class-
class-id
id
|
client-
client-id
id
|
host-name
hostname
Command
Raisecom#config
Raisecom(config)#ip dhcp client
zeroconfig polling period
Raisecom(config)#ipv6 dhcp client
zeroconfig polling period
Command
Raisecom#show ipv6 dhcp
client
Raisecom#show ip dhcp client
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Enter global configuration mode.
Configure the DHCP client to work in zero-
configuration mode or common client mode.
}
By default, it works in zero-configuration mode.
}
To disable zero-configuration, use the
command to configure the DHCP client to
common client mode.
(Optional) configure information about the DHCP
client, including the host name, class ID, and client
ID. Packets carry them when being sent by a client.
}
hour
hour
Show configurations and information
automatically obtained by the DHCP
client.
Description
Description
Enter global configuration mode.
Configure the zero-configuration
polling period, in units of hour,
ranging from 1 to 24.
By default, it is 2h.
Description
6 DHCP
260
Advertisement
Table of Contents
