Sla; Introduction - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Sending 5 ethernet cfm loopback messages to 000e.5e03.688d, timeout is
2.5 seconds:
!!!!!
Success rate is 100 percent (5/5).
Ping statistics from 000e.5e03.688d:
Received loopback replys:< 5/0/0 > (Total/Out of order/Error)
Ping successfully.
Step 4 Execute CFM fault location.
Take Switch A for example.
SwitchA(config)#service ma1 level 3
SwitchA(config-service)#traceroute mep 302 source 301
TTL: <64>
Tracing the route to 000E.5E00.0002 on level 3, service ma1.
Traceroute send via port1.
-------------------------------------------------------------------------
---------
Hops HostMac
-------------------------------------------------------------------------
---------
1
2
3
Checking results
Use the show ethernet cfm command to show CFM configurations on the ISCOM2600G-HI
series switch.
Take Switch A for example.
SwitchA#show ethernet cfm
Global CFM Admin Status: enable
Port CFM Enabled Portlist: P:1-28 PC:1-3
Archive hold time of error CCMs: 100(Min)
Remote mep aging time: 100(Min)
Device mode: Slave

9.4 SLA

9.4.1 Introduction

SLA is a telecommunication service evaluation standard negotiated by the ISP and users. It is
an agreement reached by both sides in service quality, priority, and responsibility
Ingress/EgressPort IsForwarded RelayAction NextHop
000E.5E00.0003
000E.5E00.0003
000E.5E00.0001
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
2/1 Yes
1/2 Yes
1/- No
rlyFdb 000E.5E00.0003
rlyFdb 000E.5E00.0001
rlyHit 000E.5E00.0002
9 OAM
385