Configuring Interface Rate Statistics - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
2
3
4
5
6
7
8
9
10
11
12
13

1.7.4 Configuring interface rate statistics

Configure interface rate statistics for the ISCOM2600G-HI series switch as below.
Step
1
2
Step Command
Raisecom(config)#interface
interface-type interface-
number
Raisecom(config)#interface
interface-type interface-
number
Raisecom(config-
gigaethernet1/1/port)#duple
x { full | half | auto }
Raisecom(config-
gigaethernet1/1/port)#speed
{ auto | 10 | 100 | 1000 |
10000 }
Raisecom(config-
gigaethernet1/1/port)#tpid
{ 8100 | 9100 | 88a8 }
Raisecom(config-
gigaethernet1/1/port)#jumbo
frame frame-size
Raisecom(config-
gigaethernet1/1/port)#mdi
{ xover | auto | normal }
Raisecom(config-
gigaethernet1/1/port)#vibra
tion-suppress peroid
Raisecom(config)#interface
tunnel interface-number
Raisecom(config-
tunnel1/1/1)#tunnel source
ip-address
Raisecom(config-
tunnel1/1/1)#tunnel
destination
Raisecom(config-
tunnel1/1/1)#tunnel mode
ipv6ip
Raisecom#config
Raisecom(config)#interface
interface-type interface-number
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Enter physical layer interface
configuration mode.
Enter physical layer interface
configuration mode.
Configure the duplex mode of the
interface.
Configure the interface rate.
It depends on specifications of the optical
module for the optical interface. When
there is no 10 Gbit/s interface on the
device, it does not support configuring the
10 Gbit/s rate.
(Optional) configure the interface TPID.
By default, it is 0x8100.
(Optional) configure the MTU on the
interface. The device supports configuring
MTU on interfaces in batches.
(Optional) configure the MDI/MDIX mode
of the electrical interface.
(Optional) configure the period for
suppressing vibration on the interface.
second
Create a Tunnel interface.
Configure the source IP address of the
Tunnel interface.
Configure the destination IP address of the
Tunnel interface.
ip-address
Configure the encryption type of the
Tunnel interface to IPv6 over IPv4.
Command
1 Basic configurations
Description
Description
Enter global configuration mode.
Enter physical layer interface
configuration mode.
41