Maintenance; Configuring Rate Limiting; Preparing For Configurations; Configuring Rate Limiting Based On Interface - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
No.
4
5
6

7.5.11 Maintenance

Maintain the ISCOM2600G-HI series switch as below.
Raisecom(config)#clear service-policy statistics
interface
{ ingress | egress }

7.6 Configuring rate limiting

7.6.1 Preparing for configurations

Scenario
When the network is congested, you want to restrict burst flow on an interface or VLAN to
make packets transmitted at a well-proportioned rate to remove network congestion. In this
case, you need to configure rate limiting.
Prerequisite
N/A

7.6.2 Configuring rate limiting based on interface

Configure rate limiting based on interface for the ISCOM2600G-HI series switch as below.
Step
1
2
Command
Raisecom#show policy-map [
map-name
]
Raisecom#show policy-map [
map-name
] [ class
Raisecom#show mls qos policer
policer-name
[ ]
Command
interface-type interface-number
Command
Raisecom#config
Raisecom(config)#interface
interface-type interface-number
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
policy-
policy-
class-map-name
]
Description
Show information about traffic
policy.
Show information about the
traffic class in the traffic policy.
Show information about the
assigned token bucket (rate
limiting and shaping).
Description
Clear statistics on QoS
packets.
Description
Enter global configuration mode.
Enter interface configuration
mode.
7 QoS
308