Example For Configuring Snmpv3 And Trap; Figure 12-4 Snmpv3 And Trap Networking - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
View Name: mib2
OID Tree: 1.3.6.1.2.1
Mask:
Type:
...
Use the show snmp community command to show community configurations.
Raisecom#show snmp community
Index
------------------------------------------------------------
1
2
3
Use the show snmp host command to show configurations of the target host.
Raisecom#show snmp host
Index:
IP family:
IP address:
Port:
User Name:
SNMP Version:
Security Level: noauthnopriv
TagList:

12.1.11 Example for configuring SNMPv3 and Trap

Networking requirements
As shown in Figure 12-4, the route between the NView NNM system and ISCOM2600G-HI
series switch is available, the NView NNM system monitors the Agent through SNMPv3, and
the ISCOM2600G-HI series switch can send Trap automatically to the NView NNM system
when the Agent is in emergency.
By default, there is VLAN 1 on the ISCOM2600G-HI series switch and all physical interfaces
belong to VLAN 1.

Figure 12-4 SNMPv3 and Trap networking

--
include
Community Name
private
public
raisecom
0
IPv4
20.0.0.221
162
raisecom
v2c
bridge config interface rmon snmp ospf
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
View Name
internet
internet
mib2
12 System management
Permission
rw
ro
ro
492