Default Configurations Of Vlan Mapping; Configuring Vlan Mapping; Checking Configurations - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Prerequisite




2.5.3 Default configurations of VLAN mapping

Default configurations of VLAN mapping are as below.
VLAN mapping status

2.5.4 Configuring VLAN mapping

Configure VLAN mapping for the ISCOM2600G-HI series switch as below.
1
2
3
4



2.5.5 Checking configurations

Use the following commands to check configuration results.
Connect the interface.
Configure its physical parameters to make it Up.
Create VLANs.
Function
Step
Raisecom#config
Raisecom(config)#interface
interface-type interface-number
Raisecom(config-
gigaethernet1/1/port)#switchport
vlan-mapping both outer
translate outer
Raisecom(config-
gigaethernet1/1/port)#switchport
vlan-mapping both outer
inner inner -vlan-id
vlan-id
outer
Raisecom(config-
gigaethernet1/1/1)#switchport
vlan-mapping both
translate vlan-id
Double-tagged VLAN mapping cannot be concurrently configured with basic QinQ
or tagged CVLAN/Priority-tagged VLAN mapping on the same interface.
To configure both N:1 VLAN mapping and VLAN Copy, you must configure the
VLAN Copy and then configure N:1 VLAN mapping.
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Command
vlan-id
vlan-id
vlan-id
translate
inner -vlan-id
inner
vlan-list
Default value
Disable
Description
Enter global configuration mode.
Enter physical layer interface
configuration mode.
Configure the VLAN mapping
rule based on outer and inner
VLAN Tag in both the ingress
and egress directions of the
interface.
Configure the bidirectional N:1
VLAN mapping rule.
2 Ethernet
84