Applying Traffic Policy To Interfaces; Checking Configurations - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Step
6
7
8

7.5.9 Applying traffic policy to interfaces

Apply a traffic policy to the interface for the ISCOM2600G-HI series switch as below.
Step
1
2
3

7.5.10 Checking configurations

Use the following commands to check configuration results.
No.
1
2
3
Command
Raisecom(config-pmap-
cos-
c)#set { cos
value | dscp dscp-
value
| local-
value
priority | vlan
vlan-id
| inner-vlan
inner-vlan-id
}
Raisecom(config-pmap-
c)#copy-to-mirror
mirror-id
Raisecom(config-pmap-
c)#statistics enable
Command
Raisecom#config
Raisecom(config)#interface
interface-type interface-number
Raisecom(config-
gigaethernet1/1/port)#service-
policy { ingress | egress }
policy-map-name
Command
Raisecom#show service-policy
statistics interface
interface-number
{ ingress |
egress } [ class-map
name
]
Raisecom#show service-policy
interface [ interface-type
interface-number
] [ ingress |
egress ]
Raisecom#show class-map [
name ]
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
(Optional) configure remarking rules under the
traffic class, modify packet CoS, local priority,
inner VLAN, DSCP, IP precedence, and VLAN ID.
(Optional) configure traffic mirroring to the monitor
interface.
(Optional) configure traffic statistic rules under the
traffic class, statistic packets for the matched traffic
class.
Enter global configuration mode.
Enter physical layer interface
configuration mode or VLAN
interface configuration mode.
Apply the configured traffic policy to
the ingress or egress direction of the
interface.
Show statistics about applied
interface-type
traffic policy.
class-map-
Show information about the
applied traffic policy.
class-map-
Show information about the
traffic class.
Description
Description
Description
7 QoS
307