Enabling Optical Module Ddm Trap; Checking Configurations - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
3
4

12.4.5 Enabling optical module DDM Trap

Enable optical module DDM Trap for the ISCOM2600G-HI series switch as below.
1
2
3
4

12.4.6 Checking configurations

Use the following commands to check configuration results.
1
2
3
4
Step Command
Raisecom(config)#inter
interface-type
face
interface-number
Raisecom(config-
gigaethernet1/1/port)#
transceiver ddm enable
Step Command
Raisecom#config
Raisecom(config)#snmp-
server trap
transceiver enable
Raisecom(config)#inter
face interface-type
interface-number
Raisecom(config-
gigaethernet1/1/port)#
transceiver trap
enable
No. Command
Raisecom#show transceiver
Raisecom#show transceiver
ddm interface-type
interface-list
Raisecom#show transceiver
interface-type interface-
list history [ 15m | 24h ]
Raisecom#show transceiver
information
interface-list
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Enter physical layer interface configuration
mode.
Enable interface optical module DDM.
Only when global optical DDM is enabled, the
optical module, where interface optical module
DDM is enabled, can the ISCOM2600G-HI
series switch perform DDM.
Enter global configuration mode.
Enable optical module DDM Trap globally.
Enter physical layer interface configuration
mode.
Enable interface optical module DDM Trap.
Only when global optical DDM Trap is enabled,
the optical module, where interface optical
module DDM Trap is enabled, can the
ISCOM2600G-HI series switch send Traps.
[ detail ]
interface-type
12 System management
Description
Description
Description
Show global optical module DDM and
interface optical module DDM
configurations.
Show optical module DDM performance
parameters.
Show historical information about optical
module DDM.
Show basic information about the optical
module.
511