Table of Contents
Advertisement
Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Step
3
1.7.5 Configuring flow control on interfaces
IEEE 802.3x is a flow control method for full duplex on the Ethernet data layer. When the
client sends a request to the server, it will send the PAUSE frame to the server if there is
system or network jam. Then, it delays data transmission from the server to the client.
Configure flow control on interfaces for the ISCOM2600G-HI series switch as below.
Step
1
2
3
1.7.6 Shutting down/Restarting interface
Shut down/Restart an interface for the ISCOM2600G-HI series switch as below.
Step
1
2
3
1.7.7 Configuring Console interface
Configure the Console interface for the ISCOM2600G-HI series switch as below.
Step
1
Command
Raisecom(config-
gigaethernet1/1/port)#clear
interface statistics
Command
Raisecom#config
Raisecom(config)#interface
interface-type interface-number
Raisecom(config-
gigaethernet1/1/port)#flowcontrol
{ receive | send } { off | on }
Command
Raisecom#config
Raisecom(config)#interface
interface-type interface-number
Raisecom(config-
gigaethernet1/1/port)#shutdown
Command
Raisecom#config
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Clear statistics about the interface
rate.
Enter global configuration mode.
Enter physical layer interface
configuration mode.
Enable/Disable interface flow
control over 802.3x packets.
By default, it is disabled.
Enter global configuration mode.
Enter physical layer interface
configuration mode.
Shut down the current interface.
Use the no shutdown command to
re-enable the disabled interface.
Description
Enter global configuration mode.
1 Basic configurations
Description
Description
Description
42
Advertisement
Table of Contents
