Table of Contents
Advertisement
Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Step
3
4
5
7.2.7 Configuring CoS remarking
Configure CoS remarking for the ISCOM2600G-HI series switch as below.
Step
1
2
3
4
5
6
7
7.2.8 Checking configurations
Use the following commands to check configuration results.
No.
1
Command
Raisecom(dscp-mutation)#dscp
value
to new-dscp
Raisecom(dscp-mutation)#exit
Raisecom(config)#interface
interface-type interface-number
Raisecom(config-
gigaethernet1/1/1)#mls qos dscp-
profile-id
mutation
Command
Raisecom#config
Raisecom(config)#interface
interface-type interface-number
Raisecom(config-
gigaethernet1/1/1)#mls qos cos-
remark-mapping enable
Raisecom(config-
gigaethernet1/1/1)#exit
Raisecom(config)#mls qos
mapping cos-remark
Raisecom(cos-remark)#local-
localpri-value
priority
newcos-value
Raisecom(dscp-remark)#exit
Raisecom(config)#interface
interface-type interface-number
Raisecom(config-
gigaethernet1/1/1)#mls qos cos-
profile-id
remark
Command
Raisecom#show mls qos interface
interface-type interface-
[
number
]
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
dscp-
new dscp-value
Enter global configuration mode.
Enter physical layer interface
configuration mode.
Enable CoS remarking on the interface.
Create a CoS remarking profile, and
profile-id
enter cos-remark configuration mode.
Modify the CoS remarking profile.
to cos
Enter physical layer interface
configuration mode.
Apply the DSCP remarking profile on
the interface.
Show QoS priority, trust mode, and
scheduling mode on the interface.
Description
(Optional) modify the DSCP
mutation profile. The profile used
in this configuration is the same
profile used by the mapping from
DSCP to local priority.
Enter physical layer interface
configuration mode.
Apply the DSCP mutation profile
on the interface.
Description
Description
7 QoS
298
Advertisement
Table of Contents
