Default Configurations Of Ndp; Configuring Static Neighbor Entries; Configuring Times Of Sending Ns Messages For Detecting Duplicated Addresses - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Prerequisite




5.4.3 Default configurations of NDP

Default configurations of NDP are as below.
Times of sending NS messages for detecting duplicated addresses
Maximum number of NDPs allowed to learn

5.4.4 Configuring static neighbor entries

To resolute the IPv6 address of a neighbor into the data link layer address, you can use the NS
message and NA message, or manually configure static neighbor entries.
Configure static neighbor entries for the ISCOM2600G-HI series switch as below.
1
2
5.4.5 Configuring times of sending NS messages for detecting
duplicated addresses
Configure times of sending NS messages for detecting duplicated addresses for the
ISCOM2600G-HI series switch as below.
1
2
When the ISCOM2600G-HI series switch obtains an IPv6 address, it uses the
duplicated address detection function to determine whether the IPv6 address is
already used by another device. After sending NS messages for a specified times
and receiving no response, it determines that the IPv6 address is not duplicated and
thus can be used.
Connect interfaces.
Configure physical parameters to make interfaces Up at the physical layer.
Configure the IPv6 address of the Layer 3 interface.
Step
Raisecom#config
Raisecom(config)#ipv6 neighbor
ipv6-address mac-address
Step Command
Raisecom#config
Raisecom(config-vlan1)#ipv6
nd dad attempts
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Function
Command
Enter global configuration mode.
Configure times of sending NS messages
value
for detecting duplicated addresses.
Default value
1
512
Description
Enter global configuration mode.
configure static neighbor entries
Description
5 IP services
218