Configuring Dlf Packet Forwarding; Checking Configurations; Example For Configuring Storm Control - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide





10.6.5 Configuring DLF packet forwarding

Configure DLF packet forwarding for the ISCOM2600G-HI series switch as below.
1
2

10.6.6 Checking configurations

Use the following commands to check configuration results.
1
2
3
4

10.6.7 Example for configuring storm control

Networking requirements
As shown in Figure 10-6, when GE 1/1/1 and GE 1/1/2 on the Switch receive excessive
unknown unicast packets or broadcast packets, the Switch forwards these packets to all
interfaces except the Rx interface, which may cause broadcast storm and lower forwarding
performance of the Switch.
Storm control supports only one rate limiting mode at a time. When you change
the rate limiting mode of one type of packets, the ISCOM2600G-HI series switch
will prompt you that the change of the rate limiting mode will cause the mode of
other two types of packets to change to the same mode.
To configure storm control in the VLAN, you must disable storm control on the
interface, otherwise the configuration will not take effect.
To configure storm control on the interface, you must disable storm control in the
VLAN, otherwise the configuration will not take effect.
If you configure storm control on the LAG, you cannot configure storm control on
the interface. You must disable storm control in the VLAN, otherwise the
configuration will not take effect.
Step Command
Raisecom#config
Raisecom(config)#dlf-
forwarding enable
No.
Raisecom#show storm-control
interface [
interface-number
Raisecom#show dlf-forwarding
Raisecom#show storm-control
status interface [
type interface-number
Raisecom#show storm-control
vlan-list
vlan [
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Enter global configuration mode.
Enable DLF packet forwarding on an interface.
Command
interface-type
]
interface-
]
]
Description
Description
Show configurations of storm
control.
Show DLF packet forwarding status.
Show storm control status.
Show storm control status in the
VLAN.
10 Security
429