Configuring Basic Information Of System Log; Configuring System Log Output - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide

12.5.4 Configuring basic information of system log

Configure basic information of system log for the ISCOM2600G-HI series switch as below.
1
2
3
4
5
6
7

12.5.5 Configuring system log output

Configure system log output for the ISCOM2600G-HI series switch as below.
1
Step Command
Raisecom#config
Raisecom(config)#l
ogging on
Raisecom(config)#l
ogging time-stamp
{ debug | log }
{ datetime | none
| uptime }
Raisecom(config)#l
ogging rate-limit
log-num
Raisecom(config)#l
ogging sequence-
number
Raisecom(config)#l
ogging
discriminator
distriminator
number { facility
| mnemonics | msg-
body } { { drops |
includes }
none }
Raisecom(config)#l
ogging buginf
[ high | normal |
low | none ]
Step
Raisecom#config
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Enter global configuration mode.
(Optional) enable system log.
(Optional) configure timestamp for system log.
The optional parameter debug is used to assign
debug level (7) system log timestamp; by default,
this system log does not have timestamp
The optional parameter log is used to assign debug
level 0–6 system log timestamp; by default, this
system log adopts date-time as timestamp.
(Optional) configure transmitting rate of system
log.
(Optional) configure sequence of system log.
The sequence number only applies to the console,
monitor, log file, and log buffer, but not log host
and history list.
(Optional) create and configure system log filter.
The filter can filter output log from the console,
monitor, log file and log buffer.
-
key
|
(Optional) configure sending Debug-level logs.
Command
12 System management
Description
Description
Enter global configuration
mode.
514