Configuring Ethernet Csf; Configuring Performance Monitoring; Checking Configurations - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
3

9.3.10 Configuring Ethernet CSF

Configure the Ethernet Client Signal Fail (CSF) for the ISCOM2600G-HI series switch as
below.
1
2
3
4
5

9.3.11 Configuring performance monitoring

Configure the performance monitoring for the ISCOM2600G-HI series switch as below.
1
2
3

9.3.12 Checking configurations

Use the following commands to check configuration results.
Step Command
Raisecom(config-
service)#service suppress-
alarms enable mep {
| all }
Step Command
Raisecom#config
Raisecom(config)#serv
csi-id
ice
level
Raisecom(config-
service)#service csf
enable mpid
Raisecom(config-
service)#service csf
period { 1 | 60 }
Raisecom(config-
service)#service csf
trap enable
Step Command
Raisecom#config
Raisecom(config)#service
csi-id level
Raisecom(config-
service)#service pm enable
mep { all |
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Enable alarm suppression.
By default, this function is enabled.
mep-id
Enter global configuration mode.
Enter service instance configuration mode.
ma-
level
Enable the function of sending CSF packets.
By default, this function is disabled.
mep-id
Configure the period for sending CSF packets. By
default, the period for sending CSF packets is 1s.
Enable the function of sending CSF Traps
upstream. This function is applicable to PW
OAM only.
By default, this function is disabled.
ma-level
mep-id
}
Description
Description
Description
Enter global configuration mode.
Enter service instance configuration mode.
Enable MEP performance monitoring.
9 OAM
381