Table of Contents
Advertisement
Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Step
3
4
5
6
8.5.5 Checking configurations
Use the following commands to check configuration results.
1
2
3
4
Command
Raisecom(config)#igmp mvr
vlan-id
mcast-vlan
{
start-ip-address
address
] | any }
Raisecom(config)#interface
interface-type interface-
number
Raisecom(config-
gigaethernet1/1/port)#igmp
mvr mcast-vlan
ip-address
static
vlan-id
Raisecom(config-
gigaethernet1/1/port)#igmp
mvr user-vlan
IGMP Snooping and IGMP MVR cannot be enabled concurrently in the same
multicast VLAN. Otherwise, the configuration will fail.
IGMP Snooping and multicast VLAN copy cannot be enabled concurrently in the
same multicast VLAN. Otherwise, the configuration will fail.
No.
Command
Raisecom#show igmp mvr
{ interface |
interface-number
Raisecom#show igmp mvr member
[
interface-type interface-
number
| user-vlan
Raisecom#show igmp mvr member
interface-type
count {
interface-number
vlan-id
}
Raisecom#show igmp mvr vlan-
group [ mcast-vlan
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Configure the group address set for
group
multicast VLAN.
[
end-ip-
Enter interface configuration mode.
(Optional) configure static multicast
members of MVR for a specified
vlan-id
customer VLAN.
user-vlan
(Optional) configure the range for
multicast inter-VLAN copy to take
vlan-id
effect.
interface-type
}
vlan-id
]
| user-vlan
vlan-id
]
Description
After IGMP MVR is enabled, you
need to configure multicast VLAN
and bind group address set. If the
received IGMP Report packet does
not belong to a group address set
of any VLAN, it is not processed
and the user cannot make multicast
traffic on demand.
Description
Show configurations of IGMP MVR on
the specified interface.
Show information about multicast
group members of IGMP MVR.
Show the number of multicast group
members of IGMP MVR.
Show multicast VLAN and its group
address set.
8 Multicast
342
Advertisement
Table of Contents
