Table of Contents
Advertisement
Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Step
1
2
3
4
10.8.6 Configuring priority and rate limit of IP source guard
Configure the priority and rate limit of IP source guard for the ISCOM2600G-HI series switch
as below.
Step
1
2
10.8.7 Checking configurations
Use the following commands to check configuration results.
1
2
3
10.8.8 Example for configuring IP Source Guard
Networking requirements
As shown in Figure 10-10, to prevent IP address embezzlement, you need to configure IP
Source Guard on the Switch.
Command
Raisecom#config
Raisecom(config)#ip
verify source dhcp-
snooping
Raisecom(config)#ip
source binding dhcp-
snooping static
Raisecom(config)#ip
source binding auto-
update
Raisecom#config
Raisecom(config)#ip verify source
[ ip-address ip-mask ] set-cos
value
[ rate-limit
No.
Command
Raisecom#show ip verify
source
Raisecom#show ip source
binding [
interface-type
interface-number
Raisecom#show ip verify
source set-cos
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Enter global configuration mode.
Enable IP Source Guard dynamic binding.
Translate the dynamic binding to the static
binding.
(Optional) enable auto-translation. After it is
enabled, dynamic binding entries learned through
DHCP Snooping are directly translated into static
binding entries.
Command
rate-value
]
]
Description
Description
Enter global configuration mode.
Configure the priority and rate
cos-
limit of IP source guard.
Description
Show global binding status and interface
trusted status.
Show configurations of IP Source Guard
binding, interface trusted status, and
binding table.
Show priority configurations.
10 Security
442
Advertisement
Table of Contents
