Table of Contents
Advertisement
Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Step
2
3
4
5
6
7
Command
Raisecom(config)#ethe
rnet cfm errors
archive-hold-time
minute
Raisecom(config)#serv
cis-id
ice
level
level
Raisecom(config-
service)#service cc
interval { 3ms | 10ms
| 100ms | 1 | 10 | 60
| 600}
Raisecom(config-
service)#service cc
mep-id-
enable mep {
list
| all }
Raisecom(config-
service)#service
mep-id
remote-mep
[ remote-mac
mac-
address
]
interface-type
[
interface-number
]
Raisecom(config-
service)#service
remote-mep learning
active
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Description
(Optional) configure the hold time of errored
CCMs. Fault information reported by all MEPs is
saved on the ISCOM2600G-HI series switch.
By default, the hold time of errored CCMs is
100min. When a new hold time is configured, the
system will detect the database immediately. The
data will be deleted if exceeding the hold time.
Enter service instance configuration mode.
(Optional) configure the interval for sending
CCMs.
By default, the interval for sending CCMs is 1s.
The interval for sending CCM packets cannot be
modified when CCM delivery is enabled.
When the device sends hardware CC
packets in the Down direction or the Up
direction of 802.1ag style, it can support
the 3ms | 10ms | 100ms parameters.
When it sends software CC packets in the
Up direction of the Y.1731 style, it does not
support the 3ms | 10ms | 100ms
parameters.
Enable MEPs to send CCMs.
By default, MEPs do not sending CCMs.
Configure the static RMEP. This configuration is
used with CCM detection.
You can specify the MAC address of the remote
MEP by specifying the
address
parameter.
(Optional) configure dynamic importing of
learned remote MEPs.
After this function is configured, the service
instance will converts the learned dynamic remote
MEP into the static remote MEP after CCM
packets are received.
By default, this function is disabled.
9 OAM
mac-
remote-mac
376
Advertisement
Table of Contents
