Configuring Mlacp Link Aggregation; Checking Configurations - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide

11.5.4 Configuring mLACP link aggregation

Configure mLACP link aggregation for the ISCOM2600G-HI series switch as below.
Step
1
2
3
4
5
6
7

11.5.5 Checking configurations

Use the following commands to check configuration results.
1
2
Configuration
Raisecom#config
Raisecom(config)#mlacp-
icg-id
group
Raisecom(config-ic-
group)#iccp-channel
channel-id
Raisecom(config-ic-
group)#mlacp { master |
slave }
Raisecom(config-ic-
group)#port-channel
group-id
Raisecom(config-ic-
group)#restore-mode
{ non-revertive |
revertive [ restore-
second
delay
Raisecom(config-ic-
group)#mlacp system-
system
priority
priority
No. Command
Raisecom#show iccp channel
channel-id
[
Raisecom#show iccp channel
channel-id
[
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Enter global configuration mode.
Create an ICG and enter ICG configuration
mode.
Bind the ICG with an ICCP channel.
Configure the mLACP role for the local device in
the ICG.
Bind the ICG with a LAG.
The LAG ID to be bound must be the already
established LAG ID. Otherwise, it will be
unavailable for use. For how to create a LAG, see
descriptions about the port-channel command.
Configure the LAG fault restore mode and
restore-delay time on the ICG.
] }
Configure the system priority of the local device
in the ICG.
-
By default, the mLACP system priority of the
device is 32768.
The priority of the device in the ICG should be
higher than that of the DHD. The smaller the
value is, the higher the priority will be.
Check statistics on packets received by or
] statistics
sent from the ICCP channel.
Check the configurations and running status
]
of the ICCP channel.
11 Reliability
Description
Description
477