Default Configurations Of G.8032; Creating G.8032 Ring - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
G.8032 provides a mode for detecting faults based on physical interface status. The
ISCOM2600G-HI series switch learns link fault quickly and switches services immediately,
so this mode is suitable for detecting the fault between neighboring devices.
Prerequisite





4.1.3 Default configurations of G.8032

Default configurations of G.8032 are as below.
Protocol VLAN
Protection ring mode
Ring WTR timer
Ring protocol version
Guard timer
Ring Hold-off timer
G.8032 fault reported to NMS
Tributary ring virtual channel mode in intersecting node
Ring Propagate switch in crossing node

4.1.4 Creating G.8032 ring

Configure G.8032 for the ISCOM2600G-HI series switch as below.


Step
1
Connect the interface.
Configure its physical parameters to make it Up.
Create VLANs.
Add interfaces to VLANs.
Only one device on the protection ring can be configured to the Ring Protection
Link (RPL) Owner and one device is configured to the RPL neighbor. Other
devices are configured to ring forwarding nodes.
The tangent ring consists of 2 independent single rings. Configurations on the
tangent ring are identical to the ones on the common single ring. The intersecting
ring consists of a main ring and a tributary ring. Configurations on the main ring
are identical to the ones on the common single ring. For detailed configurations of
the tributary ring, see section 4.1.6 (Optional) creating G.8032 tributary ring.
Command
Raisecom#config
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Function
Enter global configuration mode.
4 Ring network protection
Default value
1
Revertive
6min
2
500ms
0ms
Enable
With
Disable
Description
193