Figure 3-15 Isf Networking With Member Device Changing From Isf Mode To Standalone Mode - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Configuration thought
Disconnect the ISF link by manually removing the ISF cable or using CLI to shut down all
ISF physical interfaces on the master device. This example takes CLI for example.
After the ISF splits, switch the two member devices from ISF mode to standalone mode.
Networking topology

Figure 3-15 ISF networking with member device changing from ISF mode to standalone mode

Configuration steps
Step 1 Determine the master device.
Raisecom#1#show isf
Raisecom#1(config)#isf renumber 1
Raisecom#1(config)#isf mode isf
next unit is: 1, are you sure ? please input 'yes':yes
This config reboot go into effect, Please input 'yes' to reboot:yes
1970-01-01,08:07:17 System-4-SYSTEM_REBOOT:unit1: Change work Mode
reboot !
BOOTROM starting ..
Configure ISF interface 1/1/1, and bind it with physical interface Tengigabitethernet 1/1/25.
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
3 ISF
182