Table of Contents
Advertisement
Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Step
1
2
3
4
5
6.1.6 Checking configurations
Use the following commands to check configuration results.
No.
1
2
6.1.7 Example for configuring DHCP Client
Networking requirements
As shown in Figure 6-4, the Switch is used as a DHCP client, and the host name is raisecom.
The Switch is connected to the DHCP server and NMS. The DHCP server should assign IP
addresses to the SNMP interface on the Switch and make NMS manage the Switch.
Command
Raisecom#config
Raisecom(config)#in
vlan-
terface vlan
id
Raisecom(config-
vlan1)#ipv6 address
dhcp [ server-ip
ipv6-address
]
Raisecom(config-
vlan1)#ipv6 dhcp
client renew
Raisecom(config-
vlan1)#ipv6 dhcp
client rapid-commit
Command
Raisecom#show ip dhcp client
Raisecom#show ipv6 dhcp client
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Description
Enter global configuration mode.
Enter VLAN interface configuration mode.
Configure applying for IPv6 address through
DHCPv6.
If the ISCOM2600G-HI series switch has obtained an
IP address from the DHCP server through DHCPv6
before, it will restart the application process for the IP
address if you use the command to modify the IPv6
address of the DHCP server.
(Optional) renew the IPv6 address.
If the Layer 3 interface on the ISCOM2600G-HI
series switch has obtained an IP address through
DHCP, the IPv6 address will automatically be
renewed when the lease period expires.
(Optional) enable DHCPv6 Client to apply for rapid
interaction.
Show configurations of DHCP Client.
Show configurations of DHCPv6 Client.
6 DHCP
Description
256
Advertisement
Table of Contents
