Table of Contents
Advertisement
Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
12.9.2 Preparing for configurations
Scenario
After cable diagnosis is enabled, you can learn the running status of cables, locate and clear
faults, if any, in time.
Prerequisite
N/A
12.9.3 Configuring cable diagnosis
Configure cable diagnosis for the ISCOM2600G-HI series switch as below.
1
2
When you enable the function of not restarting the interface upon cable diagnosis,
the interface that is in Up status will be restarted once and then obtain cable
diagnosis data. Then, when cable diagnosis is ongoing, the interface that is in Up
status will not be restarted but directly read cable diagnosis data saved in the buffer,
and the interface that is in Down status will obtain the length to the faulty point during
cable diagnosis. The newly inserted interface will automatically execute cable
diagnosis and save results in the buffer.
12.9.4 Checking configurations
Use the following commands to check configuration results.
1
Step
Command
Raisecom(config)#test
cable-diagnostics
noshutdown enable
Raisecom#test cable-
diagnostics
type interface-number
No.
Raisecom#show cable-diagnostics
[
interface-type interface-number
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Enable the function of not restarting the
interface upon cable diagnosis.
Enable cable diagnosis. The device
interface-
supports this configuration on multiple
interfaces.
Command
12 System management
Description
Description
Show results of cable
]
diagnosis.
532
Advertisement
Table of Contents
