Table of Contents
Advertisement
Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
(Optional) configuring OAM fault indication
OAM fault indication is used by the local device to inform the peer device of local
abnormalities, such as link fault, power failure, abnormal temperature, which cause faulty link
and device restart.
You can enable or disable fault indications except link fault which must be sent to the peer
end.
Configure OAM fault indication for the ISCOM2600G-HI series switch as below.
1
2
3
Configuring local OAM event Trap
Configure local OAM event alarm for the ISCOM2600G-HI series switch as below.
1
2
3
9.2.7 Checking configurations
Use the following commands to check configuration results.
1
2
Step
Raisecom#config
Raisecom(config)#interface
interface-number
Raisecom(config-gigaethernet1/1/1)#oam
notify { critical-event | dying-gasp |
errored-frame | errored-frame-period |
errored-frame-seconds | errored-symbol-
period } enable
Step
Command
Raisecom#config
Raisecom(config)#interfac
interface-type
e
interface-number
Raisecom(config-
gigaethernet1/1/1)#oam
event trap enable
No.
Raisecom#show oam [ gigaethernet
interface-number
Raisecom#show oam event
[ gigaethernet
[ critical ]
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Command
interface-type
Enter global configuration mode.
Enter physical layer interface configuration
mode.
Enable local OAM event Trap to report link
monitoring events to the NView NNM
system immediately.
Command
]
interface-number
Description
Enter global
configuration mode.
Enter physical layer
interface configuration
mode.
Enable the OAM fault
notification to notify
the peer device of local
fault.
Description
Description
Show basic configurations of
EFM OAM.
Show remote loopback
]
configurations of EFM OAM.
9 OAM
369
Advertisement
Table of Contents
