Configuring Maximum Number Of Ndps Allowed To Be Learnt On Layer 3 Interface; Checking Configurations; Maintenance - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
5.4.6 Configuring maximum number of NDPs allowed to be learnt
on Layer 3 interface
Configure the maximum number of NDPs allowed to be learnt on the Layer 3 interface for the
ISCOM2600G-HI series switch as below.
1
2

5.4.7 Checking configurations

Use the following commands to check configuration results.
1
2
3
4
5

5.4.8 Maintenance

Maintain the ISCOM2600G-HI series switch as below.
Raisecom(config)#clear ipv6
neighbors
Step Command
Raisecom#config
Raisecom(config)#ipv6
neighbors max-learning-num
number
No. Command
Raisecom#show ipv6
neighbors
Raisecom#show ipv6
ipv6-address
neighbors
Raisecom#show ipv6
neighbors vlan
Raisecom#show ipv6
neighbors static
Raisecom#show ipv6
interface nd [ ip
number
]
Command
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Enter global configuration mode.
Configure the maximum number of NDPs
allowed to be learnt on the Layer 3 interface.
Show all NDP neighbor information.
Show neighbor information about a specified
IPv6 address.
Show neighbor information about a specified
vlan-id
layer 3 interface.
Show information about IPv6 static neighbor.
Show ND information configured on the
if-
interface.
Clear information about all IPv6 neighbors.
5 IP services
Description
Description
Description
219