Configuring Cfm Fault Detection - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
4
5
6

9.3.5 Configuring CFM fault detection

Configure CFM fault detection on the ISCOM2600G-HI series switch as below.
1
Step Command
Raisecom(config-
service)#service
vlan-list vlan-
list
[ primary-
vlan-id
vlan
Raisecom(config-
service)#service
mep [ up | down ]
mep-id
mpid
[ interface-type
interface-number
port-channel
channel
]
[ priority
priority ]
Raisecom(config-
service)#service
interface-
sdp {
type backup-
interface-number
port-channel
channel-list
interface-type
{
backup-interface-
number | port-
port-
channel
channel-list
secondary
Step Command
Raisecom#config
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Configure VLAN mapping based on the service
instance.
The VLAN list contains up to 32 VLANs. If you do
not use the primary-vlan parameter to specify the
]
primary VLAN, the minimum VLAN is taken as the
primary VLAN of the service instance. All MEPs in
the service instance send and receive packets through
this primary VLAN.
The primary VLAN is used to send and receive
packets. Therefore, all non-primary VLANs are
logically mapped to the primary VLAN. This
logical VLAN mapping is global, but VLANs
cannot be crossed. For example, service
instance 1 is mapped to VLANs 10–20 and
service instance 2 is mapped to VLANs 15–30.
Therefore, VLANs 15–20 are crossed. This
configuration is illegal.
Configure MEPs based on a service instance.
When configuring a MEP based on a service instance,
you must ensure that the service instance is mapped to
a VLAN.
By default, the MEP is Up. It indicates detecting
|
port- faults in the uplink direction.
Configure the distribution interface based on service
instance.
Only the uplink interface can be configured as the
distribution interface.
|
port-
}
}
Enter global configuration mode.
Description
Description
9 OAM
375