Configuring External Path Cost Of Interface; Configuring Maximum Transmission Rate On Interface - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide




Configure the internal path cost for the ISCOM2600G-HI series switch as below.
Step
1
2
3

2.7.10 Configuring external path cost of interface

The external path cost is the cost from the device to the CIST root, which is equal in the same
region.
Configure the external path cost for the ISCOM2600G-HI series switch as below.
Step
1
2
3

2.7.11 Configuring maximum transmission rate on interface

The maximum transmission rate on an interface means the maximum number of transmitted
BPDUs allowed by MSTP in each Hello Time. This parameter is a relative value and of no
unit. The greater the parameter is configured, the more packets are allowed to be transmitted
in a Hello Time, the more device resources it takes up. Similar with the time parameter, only
the configurations on the root device can take effect.
Configure the maximum transmission rate on the interface for the ISCOM2600G-HI series
switch as below.
1
10 Mbit/s: 2000000
100 Mbit/s: 200000
1000 Mbit/s: 20000
10 Gbit/s: 2000
Raisecom#config
Raisecom(config)#interface
type interface-number
Raisecom(config-
gigaethernet1/1/port)#spanning-tree
[ instance instance-id
cost-value
cost
Raisecom#config
Raisecom(config)#interface
interface-type interface-number
Raisecom(config-
gigaethernet1/1/port)#spanning-tree
extern-path-cost
Step
Raisecom#config
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Command
interface-
] inter-path-
Command
cost-value
Command
Description
Enter global configuration
mode.
Enter physical layer interface
configuration mode.
Configure the internal path cost
of the interface.
Description
Enter global configuration mode.
Enter physical layer interface
configuration mode.
Configure the external path cost of
the interface.
Description
Enter global configuration mode.
2 Ethernet
105