Configuring Manual Master/Slave Link Aggregation - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
8
9
10
11
12
13



11.1.5 Configuring manual master/slave link aggregation

Configure manual master/slave link aggregation for the ISCOM2600G-HI series switch as
below.
1
2
3
Step Command
Raisecom(config-port-
channel1)#lacp wait-
timer time
Raisecom(config-port-
channel1)#exit
Raisecom(config)#inte
interface-type
rface
interface-number
Raisecom(config-
gigaethernet1/1/port)
#port-channel
channel-number
Raisecom(config-
gigaethernet1/1/port)
#lacp mode { active |
passive }
Raisecom(config-
gigaethernet1/1/port)
#lacp port-priority
port-priority
In a static LACP LAG, a member interface can be an active/standby one. Both the
active interface and standby interface can receive and send LACPDU. However,
the standby interface cannot forward user packets.
The system chooses default interface in the order of neighbor discovery, interface
maximum speed, interface highest LACP priority, and interface minimum ID. The
interface is in active status by default, the interface with identical speed, identical
peer and identical device operation key is also in active status; other interfaces
are in standby status.
Step Command
Raisecom#config
Raisecom(config)#interface
port-channel
Raisecom(config-port-
channel1)#mode manual backup
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Configure the wait time on the interface.
Return to global configuration mode.
Enter Layer 2 physical interface configuration
mode.
Add the Layer 2 interface to the LAG.
(Optional) configure the LACP mode for
member interfaces. The LACP connection will
fail to be established when both ends of it are in
passive mode.
By default, it is in active mode.
(Optional) configure the interface LACP priority.
The priority affects election for the default
interface for LACP. The smaller the value is, the
higher the priority is.
By default, it is 32768.
Enter global configuration mode.
Enter LAG configuration mode.
channel-number
Configure the working mode of the LAG
to manual backup LAG.
11 Reliability
Description
Description
459