Configuring Basic Rip Functions; Configuring Rip Version - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide






5.6.2 Configuring basic RIP functions

Configure basic RIP functions for the ISCOM2600G-HI series switch as below.
Step
1
2
3
4
5

5.6.3 Configuring RIP version

Configure the RIP version for the ISCOM2600G-HI series switch as below.
Step
1
2
Split horizon: a route learned from one interface is not broadcasted to the interface.
Route poisoning: when the topology changes, the router marks an invalid route as
possibly down status and assign an unreachable matrix for it.
Poison reverse: when the router learned from one interface is sent back to the interface, it
will be poisoned; in other words, its number of hops is configured to 16, which indicates
an unreachable destination.
Trigged update: when route crash is detected, the router immediately broadcasts route
update packets rather than wait for the next update period.
Suppression timer: it prevents the routing table from changing frequently and thus
enhances network reliability.
Command
Raisecom#config
Raisecom(config)#router rip
Raisecom(config-rip)#network
ip-address
Raisecom(config-rip)#offset-
access-list-name
list
out } offset-value
interface-type interface-
[
number
]
Raisecom(config-rip)#passive-
interface-type
interface {
interface-number
Command
Raisecom#config
Raisecom(config)#router
rip
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Enter global configuration mode.
Enable RIP, and enter RIP configuration
mode.
Configure a directly-connected and
effective network based on RIP.
Configure the additional metrics when
{ in |
the interface receives or sends RIP
routes.
By default, it is 0.
(Optional) configure the interface to be a
passive interface.
| default }
By default, it is a non-passive interface.
Enter global configuration mode.
Enable RIP, and enter RIP configuration
mode.
5 IP services
Description
Description
226