Configuring Basic Functions Of Efm - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
Remote OAM event alarm
EFM remote loopback status
Monitor window of errored frame event
Monitor threshold of errored event
Monitor window of errored frame period event
Monitor threshold of errored frame period event
Monitor window of link errored frame second statistics event
Monitor threshold of link errored frame second statistics event
Monitor window of link errored coding statistics event
Monitor threshold of errored coding statistic event
Fault indication
Local OAM event alarm

9.2.4 Configuring basic functions of EFM

Configure basic functions of EFM for the ISCOM2600G-HI series switch as below.
1
2
3
4
5
6
Step Command
Raisecom#config
Raisecom(config)#interf
interface-type
ace
interface-number
Raisecom(config-
gigaethernet1/1/1)#oam
{ active | passive }
Raisecom(config-
gigaethernet1/1/1)#exit
Raisecom(config)#oam
send-period
number
Raisecom(config)#oam
period-number
timeout
Raisecom(config)#interf
interface-type
ace
interface-number
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Function
Enter global configuration mode.
Enter physical layer interface configuration
mode.
Configure the working mode of EFM OAM.
At least one end should be in active mode,
otherwise link detection will fail.
(Optional) Configure the period for sending
period-
OAM PDUs.
(Optional) configure the timeout of EFM OAM
links.
When the duration of failing to receive OAM
packets by one end of the OAM link is greater
than the timeout, the end regards that the OAM
link is disconnected.
Enter physical layer interface configuration
mode.
Default value
Disable
Not response
1s
1 errored frame
1000ms
1 errored frame
60s
1s
1s
1s
Enable
Disable
Description
9 OAM
365