Example For Configuring Vlan; Figure 2-4 Vlan And Interface Protection Networking - Raisecom ISCOM2600G-HI (A) Series Configuration Manual

Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
No.
3
4
5
6

2.2.12 Example for configuring VLAN

Networking requirements
As shown in Figure 2-4, PC 1, PC 2, and PC 5 belong to VLAN 10, PC 3 and PC 4 belong to
VLAN 20; Switch A and Switch B are connected by the Trunk interface; PC 3 and PC 4
cannot communicate because VLAN 20 is not allowed to pass in the link; PC 1 and PC 2
under the same Switch B are enabled with interface protection function so that they cannot
communicate with each other, but can respectively communicate with PC 5.

Figure 2-4 VLAN and interface protection networking

Configuration steps
Step 1 Create VLAN 10 and VLAN 20 on the two switches respectively, and activate them.
Configure Switch A.
Command
Raisecom#show mac-vlan aging-
time
Raisecom#show switchport
interface-type interface-number
Raisecom#show protocol-vlan all
Raisecom#show protocol-vlan
interface interface-type
interface-number
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Description
Show the aging time of MAC VLANs.
Show VLAN configurations on the
interface.
Show configurations of all protocol
VLANs.
Show configurations of the protocol
VLAN on the interface.
2 Ethernet
65