Table of Contents
Advertisement
Raisecom
ISCOM2600G-HI (A) Series Configuration Guide
9.4.4 Default configurations of SLA
Default configurations of SLA are as below.
SLA operation scheduling status
SLA Layer 2 operation CoS
Probe interval for SLA packet loss
operations
Life period for scheduling SLA operations
Test period for scheduling SLA operations
SLA alarm status
9.4.5 Creating SLA operation
Create an SLA operation for the ISCOM2600G-HI series switch as below.
All following steps are optional and in any sequence.
1
2
3
4
5
is for service packets of the UNI interface. For Down MEP, the statistics result is for
service packets of the NNI interface.
Packet loss ratio is for service packets, so SLA protocol packets should not be discarded.
If SLA protocol packets are discarded, packet loss rate cannot be tested.
Function
Step
Raisecom#config
Raisecom(config)#sla
y1731–pkt-loss slm remote-mac
address
level
id
[ cos
cos-value
interval-num
Raisecom(config)#sla
y1731–pkt-loss slm remote-mep
num
level
[ cos
cos-value
interval-num
Raisecom(config)#sla
description
Raisecom(config)#sla private-tlv
enable
Raisecom Proprietary and Confidential
Copyright © Raisecom Technology Co., Ltd.
Disable
0
1s
Forever
300s
Command
oper-num
level-id
svlan
] [ interval
size
] [ size
]
oper-num
level-id
vlan-id
svlan
] [ interval
] [ size
size
]
oper-num
string
Default value
Availability status change alarm: disable
Threshold alarm status: disable
Description
Enter global configuration
mode.
(Optional) configure SLA
mac-
Y1731-pkt-loss operation
vlan-
according to the destination
MAC address.
(Optional) configure SLA
mep-
Y1731-pkt-loss operation
according to the destination
MEP.
owner
(Optional) configure the
description of the SLA
operation user.
(Optional) enable the function
of padding the SLA operation
with the private TLV.
By default, this function is
disabled.
9 OAM
388
Advertisement
Table of Contents
